Tow Truck Toys

4-Wheel & Off Road January 2004

by David Kennedy

photography David Kennedy

Duramax Upgrades for Power and Braking

Tow Truck Toys
 The Banks Stinger Kit improves engine breathing with a complete 4-inch mandrel-bent stainless steel exhaust, a free-flowing drop=in air filter, and a replacement waste-gate actuator that permits the turbocharger to build more boost. Additional fuel is then added with Banks’ OttoMind inline computer that alters the data flowing in and out of the Duramax’s ECM to make the engine produce more power. Auxiliary gauges are included in the kit to monitor boost pressure and EGT.
Banks Brake® Banks Brake Exhaust
Chart

If you’ve towed with a Duramax-equipped truck you already know how potent these engines are in stock form. But the 300 hp and 520 lb-ft of torque that once had an amazing effect on your Jeep trailer may not feel that strong anymore now that you’re in the market for a bigger trailer or hauling more stuff. We know you don’t want to get rid of your truck, so while researching ’01-03 Duramax power upgrades for this issue we think we might have found the solution to your problem at Gale Banks Engineering

We shadowed the calibration engineers at Banks as they put the finishing touches on its newest GM diesel products, and we even got to drive some of the test mules around the Azusa, California, facility before anyone else. What we found will add a lot more go! and even more whoa! to your vehicle.

Exhaust Brake Install

One of the Duramax test vehicles we drove was equipped with Banks’ exhaust brake to facilitate safer, more controlled braking. This butterfly valve mounts in the exhaust stream and can restrict exhaust flow to add compression braking when the system is switched on and the driver’s foot is not on the accelerator. To test the effectiveness of the exhaust brake, we made four identical runs down a moderate grade starting at 60 mph with 10,000 pounds in tow. Here’s what we found:

First Run: Truck began coasting downhill at 60 mph without the exhaust or truck’s brakes applied. Truck accelerated to over 75 mph due to the trailer weight and we had to apply the truck’s brakes to maintain control.

Second Run: Repeated the 60-mph test condition at the top of the hill but this time we squeezed the truck’s brakes till about 55 mph to activate the Allison’s Tow/Haul mode downshift schedule, and let the transmission do its thing. The truck’s speed held to roughly 65 mph with no additional use of the truck’s brakes.

Third Run: With the Banks exhaust brake engaged and no use of the truck’s brakes the truck held a comfortable 60- to 65-mph speed with a mild burbling sound from the engine and a light whooshing sound from the exhaust.

Fourth Run: Engaged the Banks Brake and applied the truck’s brakes till the vehicle slowed to 55 mph. The truck’s brakes were then released and the Banks exhaust brake and the Allison’s Tow/Haul mode downshifting schedule complemented each other perfectly to slow the truck to a comfortable 55-50 mph.

 

Power Increase

We were on hand to watch as Banks put the finishing touches on its new engine calibration for the Stinger kit. We had the pleasure of driving the development truck in both stock and modified form and are pleased to say we could feel every one of the those extra horses and pound feet (Approximately 80 hp and 200 lb-ft in our case. This kind of power increase will keep you out of the slow lane — even when towing!

 

Leave a Reply